Dell PowerConnect 5324 Command Line Interface Reference Manual

Line Commands 175
Syntax
exec-timeout minutes [ seconds ]
no exec-timeout
•
minutes —Integer that specifies the number of minutes. (Range: 0 - 65535)
•
seconds —Additional time intervals in seconds. (Range: 0 - 59)
Default Configuration
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
User Guidelines
• To specify no timeout, enter the exec-timeout ("0 0") command.
Examples
The following example configures the interval that the system waits until user input is detected to
20 minutes.
show line
The show line User EXEC mode command displays line parameters.
Syntax
show line [console | telnet | ssh ]
•
console —Console terminal line.
•
telnet —Virtual terminal for remote console access (Telnet).
•
ssh —Virtual terminal for secured remote console access (SSH).
Default Configuration
Default value is console .
Command Mode
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Console (config)# line console
Console(config-line)# exec-timeout 20

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2