Dell PowerConnect 5324 - Show Interfaces Status

Ethernet Configuration Commands 129
The displayed port configuration information includes the following:
•
Port —The port number.
•
Port Type —The port designated IEEE shorthand identifier. For example 1000Base-T refers to
1000 Mbps baseband signaling.
•
Duplex —Displays the port Duplex status.
•
Speed —Refers to the port speed.
•
Neg —Describes the Auto-negotiation status.
•
Flow Control —Displays the Flow Control status.
•
Back Pressure —Displays the Back Pressure status.
•
MDIX Mode —Displays the Auto-crossover status.
•
Admin State —Displays whether the port is enabled or disabled.
show interfaces status
The show interfaces status User EXEC mode command displays the status for all configured
interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number ]
•
interface —A valid Ethernet port.
•
port-channel-number— A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Privilege EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the status for all configured interfaces.