Dell PowerConnect 5324 - Set Interface Active; Show Interfaces Configuration

Ethernet Configuration Commands 127
Command Mode
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
In the following example, the counters for interface g1 are cleared.
set interface active
The set interface active Privileged EXEC mode command reactivates an interface that was
suspended by the system.
Syntax
set interface active { ethernet interface | port-channel port-channel-number }
•
interface —Valid Ethernet port.
•
port-channel-number— Valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Privilege EXEC mode
User Guidelines
• This command is used to activate interfaces that were configured to be active, but were
shutdown for some reason.
Example
The following example activates interface g5, which is disabled.
show interfaces configuration
The show interfaces configuration Privilege EXEC mode command displays the configuration for
all configured interfaces.
Console# clear counters ethernet g1
Console# set interface active ethernet g5