Dell PowerConnect 5324 Command Line Interface Reference Manual

LACP Commands 169
LACP Commands
lacp system-priority
The lacp system-priority Global Configuration mode command configures the system priority. To
reset to default, use the
no form of this command.
Syntax
lacp system-priority value
no lacp system-priority
• value —Value of the priority. (Range: 1 - 65535)
Default Configuration
The default system priority value is 1.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the system priority to 120.
lacp port-priority
The lacp port-priority Interface Configuration mode command configures the priority value for
physical ports. To reset to default priority value, use the
no form of this command.
Syntax
lacp port-priority value
no lacp port-priority
• value —Port priority value. (Range: 1 - 65535)
Default Configuration
The default port priority value is 1.
Console (config)# lacp system-priority 120

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2