Dell PowerConnect 5324 Command Line Interface Reference Manual

372 802.1x Commands
www.dell.com | support.dell.com
dot1x system-auto-control
The dot1x system-auto-control Global Configuration mode command enables 802.1x globally. Use
the
no form of this command to disable 802.1x globally.
Syntax
dot1x system-auto-control
no dot1x system-auto-control
• This command has no arguments or keywords.
Default Configuration
Disabled
Command Modes
Global configuration mode
User Guidelines
• There are no user guidelines for this command.
Examples
The following example enables 802.1x globally.
dot1x port-control
The dot1x port-control Interface Configuration mode command enables manual control of the
authorization state of the port. Use the
no form of this command to return to the default setting.
Syntax
dot1x port-control { auto | force-authorized | force-unauthorized }
no dot1x port-control
•
auto— Enable 802.1X authentication on the interface and cause the port to transition to
the authorized or unauthorized state based on the 802.1X authentication exchange
between the switch and the client.
•
force-authorized— Disable 802.1X authentication on the interface and cause the port to
transition to the authorized state without any authentication exchange required. The
port resends and receives normal traffic without 802.1X-based authentication of the
client.
•
force-unauthorized— Deny all access through this interface by forcing the port to
transition to the unauthorized state, ignoring all attempts by the client to authenticate.
The switch cannot provide authentication services to the client through the interface.
Console (config)# dot1x system-auto-control

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2