Dell PowerConnect 5324 Command Line Interface Reference Manual

IGMP Snooping Commands 153
show ip igmp snooping mrouter
The show ip igmp snooping mrouter User EXEC mode command displays information on
dynamically learned multicast router interfaces.
Syntax
show ip igmp snooping mrouter [ interface vlan-id ]
•
vlan_id— VLAN ID value.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example shows IGMP snooping mrouter information.
show ip igmp snooping interface
The show ip igmp snooping interface User EXEC mode command displays IGMP snooping
configuration.
Syntax
show ip igmp snooping interface vlan-id
• vlan_id— VLAN ID value.
Default Configuration
This command has no default configuration.
Console # show ip igmp snooping mrouter
VLAN Ports
---- ------
2g1

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2