Dell PowerConnect 5324 Command Line Interface Reference Manual

384 802.1x Commands
www.dell.com | support.dell.com
ADVANCED FEATURES
dot1x auth-not-req
The dot1x auth-not-req VLAN Configuration mode command enables unauthorized users access
to that VLAN. Use the
no form of this command to disable the access.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
This command has no arguments or keywords.
Default Configuration
User should be authorized to access the VLAN.
Command Mode
VLAN Configuration mode
User Guidelines
• An access port cannot be a member in an unauthenticated VLAN. The native VLAN of a
trunk port cannot be an unauthenticated VLAN. For a general port, the PVID can be the
Unauthenticated VLAN (although only tagged packets would be accepted in Unauthorized
state.)
Examples
The following example enables unauthorized users access to the VLAN.
EapolReqFramesTx The number of EAP Request frames (other than Rq/Id frames) that have
been transmitted by this Authenticator.
InvalidEapolFramesRx The number of EAPOL frames that have been received by this
Authenticator in which the frame type is not recognized.
EapLengthErrorFramesRx The number of EAPOL frames that have been received by this
Authenticator in which the Packet Body Length field is invalid.
LastEapolFrameVersion The protocol version number carried in the most recently received
EAPOL frame.
LastEapolFrameSource The source MAC address carried carried in the most recently received
EAPOL frame.
console config-if(Config-VLAN)# dot1x auth-not-req

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2