Dell PowerConnect 5324 Command Line Interface Reference Manual

IP Addressing Commands 157
IP Addressing Commands
clear host dhcp
The clear host dhcp Privileged EXEC mode command deletes entries from the host name-to-
address mapping received from Dynamic Host Configuration Protocol (DHCP).
Syntax
clear host dhcp { name | *}
• name—Particular host entry to remove. (Range: 1 - 158 characters.)
• *— Removes all entries.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
• This command would delete the host name-to-address mapping temporarily until the next
renew of the IP address.
Examples
The following example deletes all entries from the host name-to-address mapping.
ip address
The ip address Interface Configuration mode command sets an IP address. To remove an IP
address, use the
no form of this command.
Syntax
ip address ip-address { mask | prefix-length }
no ip address [ ip-address ]
•
ip-address —IP address
•
mask —Specifies the network mask of the IP address. (Range: Valid Subnet mask)
Console# clear host dhcp *

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2