Dell PowerConnect 5324 Command Line Interface Reference Manual

Radius Commands 223
radius-server deadtime
The radius-server deadtime Global Configuration mode command improves RADIUS response
times when servers are unavailable. The command is used to cause the unavailable servers to be
skipped. To reset the default value, use the
no form of this command.
Syntax
radius-server deadtime deadtime
no radius-server deadtime
• deadtime —Length of time in minutes, for which a RADIUS server is skipped over by
transaction requests. (Range: 0 - 2000)
Default Configuration
The default dead time is 0 minutes.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example sets a dead time where a RADIUS server is skipped over by transaction
requests for this period, to 10 minutes.
show radius-servers
The show radius-servers User EXEC mode command displays the RADIUS server settings.
Syntax
show radius-servers
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
Console (config)# radius-server deadtime 10

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2