Dell PowerConnect 5324 Command Line Interface Reference Manual

222 Radius Commands
www.dell.com | support.dell.com
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the source IP address used for communication with RADIUS
servers to 10.1.1.1.
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval for which a
device waits for a server host to reply. To restore the default, use the
no form of this command.
Syntax
radius-server timeout timeout
no radius-server timeout
• timeout —Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example sets the interval for which a device waits for a server host to reply to
5 seconds.
Console (config)# radius-server source-ip 10.1.1.1
Console (config)# radius-server timeout 5

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2