Dell PowerConnect 5324 Command Line Interface Reference Manual

274 Spanning-Tree Commands
www.dell.com | support.dell.com
Default Setting
The default configuration revision number is 0.
Command Mode
MST Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example sets the configuration revision to 1.
show (mst)
The show MST Configuration mode command displays the current or pending MST region
configuration.
Syntax
show {current | pending}
• current — Indicates the current region configuration.
•
pending — Indicates the pending region configuration.
Default Setting
This command has no default configuration.
Command Mode
MST Configuration mode
User Guidelines
• The pending MST region configuration takes effect only after exiting the MST configuration
mode.
Example
The following example displays a pending MST region configuration.
Console(config) # spanning-tree mst configuration
Console(config-mst) # revision 1
Console(config-mst)# show pending
Pending MST configuration

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2