Dell PowerConnect 5324 Command Line Interface Reference Manual

386 802.1x Commands
www.dell.com | support.dell.com
• forward —Forward frames with source addresses not the supplicant address, but do not
learn the address.
•
discard —Discard frames with source addresses not the supplicant address.
•
discard-shutdown —Discard frames with source addresses not the supplicant address.
The port is also shutdown.
•
trap seconds —Send SNMP traps, and specifies the minimum time between consecutive
traps. (Range: 1-
1000000 )
Default Configuration
Discard frames with source addresses not the supplicant address. No traps.
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
• The command is relevant when Multiple hosts is disabled and the user has been successfully
authenticated
Examples
The following example uses the forward action to forward frames with source addresses.
show dot1x advanced
The show dot1x advanced Privileged EXEC mode command displays 802.1X advanced features for
the switch or for the specified interface.
Syntax
show dot1x advanced [ ethernet interface ]
•
interface— Ethernet interface
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
console config-if(Config-VLAN)# dot1x single-host-violation
forward trap 100

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2