Dell PowerConnect 5324 Command Line Interface Reference Manual

Clock 99
Default Configuration
1024
Command Mode
Global configuration mode
User Guidelines
• There are no user guidelines for this command.
Examples
The following example sets the polling time for the Simple Network Time Protocol (SNTP) client
to 120 seconds.
sntp broadcast client enable
The sntp broadcast client enable Global Configuration mode command enables the Simple
Network Time Protocol (SNTP) broadcast clients. To disable the SNTP broadcast clients, use the
no form of this command.
Syntax
sntp broadcast client enable
no sntp broadcast client enable
This command has no arguments or keywords.
Default Configuration
Disabled
Command Mode
Global configuration mode
User Guidelines
• The sntp broadcast client enable Interface Configuration mode command enables the device
to receive broadcast transmissions globally and on ALL interfaces.
• Use the
sntp client enable Interface Configuration mode command to enable the SNTP
client on a specific interface.
Examples
The following example enables the SNTP broadcast clients.
Console (config)# sntp client poll timer 120
Console (config)# sntp broadcast client enable

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2