Dell PowerConnect 5324 Command Line Interface Reference Manual

Syslog Commands 307
logging file
The logging file Global Configuration mode command limits syslog messages sent to the logging
file based on severity. To cancel the buffer, use the
no form of this command.
Syntax
logging file level
no logging file
• level —Limits the logging of messages to the buffer to a specified level: emergencies,
alerts
, critical , errors, warnings , notifications, informational and debugging.
Default Configuration
The default severity level is errors .
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example limits syslog messages sent to the logging file based on the severity level
"alerts".
clear logging file
The clear logging file Privileged EXEC mode command clears messages from the logging file.
Syntax
clear logging file
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
Console (config)# logging file alerts

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2