Port Channel Commands 201
Port Channel Commands
interface port-channel
The
interface port-channel
Global Configuration mode command enters the interface
configuration mode of a specific port-channel.
Syntax
interface port-channel
port-channel-number
•
port-channel-number
—A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
• Eight aggregated links can be defined with up to 8 member ports per port channel.Turning off
auto-negotiation of an aggregate link may, under some circumstances, make it non-
operational. If the other side has auto-negotiation turned on, it may re-synchronize all
members of the aggregated link to half-duplex operation, and may, as per the standards, set
them all to inactive.
Example
The following example enters the context of port-channel number 1.
interface range port-channel
The
interface range port-channel
Global Configuration mode command enters the interface
configuration mode to configure multiple port-channels.
Syntax
interface range
port-channel
{
port-channel-range | all
}
•
port-channel-range
—List of port-channels to configure. Separate non-consecutive port-
channels with a comma and no spaces. A hyphen designates a range of port-channels.
•
all
—All the channel-ports.
Console (config)# interface port-channel 1
To Next Page
Loading...
