Dell PowerConnect 5324 Command Line Interface Reference Manual

802.1x Commands 375
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Examples
• The following command manually initiates a re-authentication of the 802.1X-enabled port.
dot1x timeout quiet-period
The dot1x timeout quiet-period Interface Configuration mode command sets the number of
seconds that the switch remains in the quiet state following a failed authentication exchange (for
example, the client provided an invalid password). Use the
no form of this command to return to
the default setting.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
• seconds— Time in seconds that the switch remains in the quiet state following a failed
authentication exchange with the client. (Range: 0 - 65535 seconds)
Default Configuration
60
Command Mode
Interface configuration (Ethernet)
User Guidelines
• During the quiet period, the switch does not accept or initiate any authentication requests.
• The default value of this command should only be changed to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with certain clients
and authentication servers.
• If it is necessary to provide a faster response time to the user, a smaller number than the
default should be entered.
Console# dot1x re-authenticate ethernet g8

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2