Dell PowerConnect 5324 Command Line Interface Reference Manual

VLAN Commands 345
Syntax
switchport general allowed vlan add vlan-list [ tagged | untagged ]
switchport general allowed vlan remove vlan-list
• add vlan-list —List of VLAN IDs to add. Separate non consecutive VLAN IDs with a
comma and no spaces. A hyphen designates a range of IDs.
•
remove vlan-list —List of VLAN IDs to remove. Separate non consecutive VLAN IDs with
a comma and no spaces. A hyphen designates a range of IDs.
•
tagged —Sets the port to transmit tagged packets for the VLANs. If the port is added to a
VLAN without specifying tagged or untagged the default is tagged.
•
untagged —Sets the port to transmit untagged packets for the VLANs.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
• You can use this command to change the egress rule (e.g. from tagged to untagged), without
first removing the VLAN from the list.
Example
The following example shows how to add VLANs 2, 5, and 6 to the allowed list.
switchport general pvid
The switchport general pvid Interface Configuration mode command configures the PVID when
the interface is in general mode. To configure the default value, use the
no form of this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
• vlan-id —PVID (Port VLAN ID). The vlan-id may belong to a non-existent VLAN.
Default Configuration
VLAN ID=1
Console (config)# interface ethernet g8
Console (config-if)# switchport general allowed vlan add 2,5,6
tagged

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2