Dell PowerConnect 5324 - Show Snmp Views

SNMP Commands 255
.
show snmp views
To display the configuration of views use the show snmp views Privileged EXEC command
Syntax
show snmp views [ viewname ]
•
viewname — The name of the view. Range: Up to 30 characters
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged EXEC
User Guidelines
• There are no user guidelines for this command
Example
The following example displays the configuration of views use the show snmp views Privileged
EXEC command.
Traps are enabled.
Authentication trap is enabled.
Version 1,2 notifications
Target
Address
Type Communit
y
Version UDP Port Filter
name
TO sec
Retrie
s
Version 3 notifications
Target
Address
Type Username Secu-
rity
Level
UDP Port Filter
name
TO sec Retrie
s
System Contact:
System Location:
console#