88 Address Table Commands
www.dell.com | support.dell.com
show bridge address-table count
The
show bridge address-table count
Privileged EXEC mode command displays the number of
addresses present in all VLANs or in a specific VLAN.
Syntax
show bridge address-table count
[
vlan
vlan
]
•
vlan
—Specific VLAN.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
• This command displays the count for 1 VLAN, for all VLANs or for a specific port.
• No commas are allowed.
Example
In this example, the number of addresses present in the VLANs are displayed.
Console# show bridge address-table static
Aging time is 300 sec
vlan mac address port type
---- ----------- ---- ----
1 00:60:70:4C:73:FF g8 permanent
1 00:60:70:8C:73:FF g8 delete-on-timeout
200 00:10:0D:48:37:FF g8 delete-on-reset
To Next Page
Loading...
