Dell PowerConnect 5324 Command Line Interface Reference Manual

174 Line Commands
www.dell.com | support.dell.com
Command Mode
Line Configuration (console) mode
User Guidelines
• The configured speed would be applied when Autobaud is disabled.
• If Autobaud is disabled, the new speed is implemented immediately.
Examples
The following example sets the baud rate to 9600.
autobaud
The autobaud Line Configuration mode command sets the line for automatic baud rate detection
(autobaud). Use the
no form of this command to disable automatic baud rate detection.
Syntax
autobaud
no autobaud
Default Configuration
Disabled
Command Mode
Line Configuration (console) mode
User Guidelines
• To start communications using automatic baud detection, press the Enter key twice.
Examples
The following example sets the line for automatic baud rate detection.
exec-timeout
The exec-timeout Line Configuration mode command sets the interval that the system waits until
user input is detected. To restore the default setting, use the
no form of this command.
Console (config)# line console
Console(config-line)# speed 9600
Console (config)# line console
Console(config-line)# autobaud

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2