Dell PowerConnect 5324 - Enable Authentication

68 AAA Commands
www.dell.com | support.dell.com
Default Configuration
Uses the default set with the command authentication login .
Command Mode
Line Configuration mode
User Guidelines
• Changing login authentication from default to another value may disconnect the telnet
session.
Example
The following example specifies the default authentication method for a console.
enable authentication
The enable authentication Line Configuration mode command specifies the authentication
method list when accessing a higher privilege level from a remote telnet, SSH or console. To return
to the default specified by the
enable authentication command, use the no form of this command.
Syntax
enable authentication { default | list-name }
no enable authentication
• default —Uses the default list created with the authentication enable command.
•
list-name —Uses the indicated list created with the authentication enable command.
Default Configuration
Uses the default set with the command authentication enable .
Command Mode
Line Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example specifies the default authentication method when accessing a higher
privilege level from a console.
Console (config)# line console
Console (config-line)# login authentication default