Dell PowerConnect 5324 Command Line Interface Reference Manual

154 IGMP Snooping Commands
www.dell.com | support.dell.com
Command Mode
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The example displays IGMP snooping information.
show ip igmp snooping groups
The show ip igmp snooping groups User EXEC mode command displays the multicast groups
learned by IGMP snooping.
Syntax
show ip igmp snooping groups [ vlan vlan-id ] [ address ip-multicast-address ]
•
vlan_id— VLAN ID value.
•
ip-multicast-address— IP multicast address.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
• To see the full multicast address table (including static addresses) use the show bridge
address-table
command.
Console # show ip igmp snooping interface 1
IGMP Snooping is globaly disabled
IGMP Snooping is disabled on VLAN 1
IGMP host timeout is 260 sec
IGMP Immediate leave is disabled. IGMP leave timeout is 60 sec
IGMP mrouter timeout is 300 sec
Automatic learning of multicast router ports is enabled

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2