Dell PowerConnect 5324 Command Line Interface Reference Manual

Spanning-Tree Commands 275
exit (mst)
The exit MST Configuration mode command exits the MST configuration mode and applies all
configuration changes.
Syntax
exit
Default Setting
This command has no default configuration.
Command Mode
MST Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example exits the MST configuration mode and saves changes.
abort (mst)
The abort MST Configuration mode command exits the MST configuration mode without applying
the configuration changes.
Syntax
abort
Default Setting
This command has no default configuration.
Name:
Region1
Revision: 1
Instance Vlans Mapped State
-------- ------------ -------
0 1-9,21-4094 Enabled
1 10-20 Enabled
Console(config) # spanning-tree mst configuration
Console(config-mst) # exit

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2