EasyManuals Logo

Dell PowerConnect 5324 Command Line Interface Reference Manual

Dell PowerConnect 5324
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Address Table Commands 77
Address Table Commands
bridge address
The
bridge address
VLAN Interface Configuration mode command adds a static MAC-layer
station source address to the bridge table. To delete the MAC address, use the
no
form of the
bridge address
command (using the
no
form of the command without specifying a MAC address
deletes all static MAC addresses belonging to this VLAN).
Syntax
bridge address
mac-address
{
ethernet
interface | port-channel port-channel-number
}
[
permanent
|
delete-on-reset
|
delete-on-timeout
|
secure
]
no bridge address
[
mac-address
]
mac-address
—A valid MAC address in the format of xx:xx:xx:xx:xx:xx.
interface—
A valid Ethernet port.
port-channel-number—
A valid port-channel number.
permanent—
The address can only be deleted by the
no bridge address
command.
delete-on-reset
—The address is deleted after reset.
delete-on-timeout—
The
address is deleted after "age out" time has expired.
secure
—The address is deleted after the port changes mode to unlock learning (
no port
security
command). This parameter is only available when the port is in learning locked
mode.
Default Configuration
No static addresses are defined. The default mode for an added address is
permanent
.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example adds a permanent static MAC-layer station source address 3aa2.64b3.a245
on port g8 to the bridge table.

Table of Contents

Other manuals for Dell PowerConnect 5324

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 5324 and is the answer not in the manual?

Dell PowerConnect 5324 Specifications

General IconGeneral
Switching Capacity48 Gbps
VLAN SupportYes
Rack MountableYes
Device TypeSwitch
MAC Address Table Size8K entries
RAM64 MB
Flash Memory8 MB
Power DeviceInternal power supply
Voltage RequiredAC 120/230 V (50/60 Hz)
Jumbo Frame SupportYes
Ports24 x 10/100/1000 + 2 x SFP
ManagementWeb-based, SNMP, CLI
Enclosure TypeRack-mountable
Routing ProtocolStatic IP routing
Remote Management ProtocolSNMP 1, 2, 3
FeaturesFlow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature0 °C to 45 °C
Storage Temperature-20 °C to 70 °C
Humidity5% to 95% (non-condensing)
LayerLayer 2

Related product manuals