Dell PowerConnect 5324 Command Line Interface Reference Manual

306 Syslog Commands
www.dell.com | support.dell.com
Syntax
logging buffered size number
no logging buffered size
• number —Numeric value indicating the maximum number of messages stored in the
history table. (Range: 20 - 400)
Default Configuration
The default number of messages is 200.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example changes the number of syslog messages stored in the internal buffer to 300.
clear logging
The clear logging Privileged EXEC mode command clears messages from the internal logging
buffer.
Syntax
clear logging
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example clears messages from the internal syslog message logging buffer.
Console (config)# logging buffered size 300
Console# clear logging
Clear logging buffer [y/n] y

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2