Dell PowerConnect 5324 Command Line Interface Reference Manual

VLAN Commands 355
no switchport mode
• customer — The port is connected to customer equipment. Used when the switch is in a
provider network.
•
access — Untagged layer 2 VLAN interface
•
trunk — Trunking layer 2 VLAN interface
•
general — Full 802.1q support VLAN interface
Default Configuration
All ports are in access mode, and belong to the default VLAN (whose VID=1).
Command Modes
Interface configuration (Ethernet, port-channel)
User Guidelines
• There are no user guidelines for this command
Example
The following example onfigures the VLAN membership mode of a port. Use the no form of this
command to reset the mode to the appropriate default for the device.
switchport customer vlan
Use the switchport customer vlan interface configuration command to set the port's VLAN when
the interface is in customer mode. Use the
no form of this command to revert to default.
Syntax
switchport customer vlan vlan-id
no switchport customer vlan
• vlan-id — V LAN ID of the customer
Default Configuration
No VLAN is configured.
Command Modes
Interface configuration (Ethernet, port-channel)
console# config
console(config)# interface ethernet g1
console(config-if)# switchport mode customer

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2