SNMP Commands 251
Example
The following example configures a new SNMP Version 3 use
r.
snmp-server v3-host
The
snmp-server v3-host
Global Configuration mode command specifies the recipient of Simple
Network Management Protocol Version 3 notifications. To remove the specified host, use the
no
form of this command.
Syntax
snmp-server v3-host {
ip-address
|
hostname
}
username
[traps | informs] {noauth | auth |
priv} [udp-port
port
] [filter
filtername
] [timeout
seconds
] [retries
retries
]
no snmp-server host {
ip-address
|
hostname
}
username
[traps | informs]
•
ip-address
—Specifies the IP address of the host (targeted recipient).
•
hostname
—Specifies the name of the host. (Range:1-158 characters).
•
username
—Specifies the name of the user to use to generate the notification. (Range: 1-
24)
•
traps
— Indicates that SNMP traps are sent to this host.
•
informs
— Indicates that SNMP informs are sent to this host.
•
noauth
— Indicates no authentication of a packet.
•
auth
— Indicates authentication of a packet without encrypting it.
•
priv
— Indicates authentication of a packet with encryption.
•
port
— Specifies the UDP port of the host to use. If unspecified, the default UDP port
number is 162.
(Range: 1-65535)
•
filtername
— Specifies a string that defines the filter for this host. If unspecified, nothing
is filtered.
(Range: 1-30 characters)
•
seconds
— Specifies the number of seconds to wait for an acknowledgment before
resending informs. If unspecified, the default timeout period is 15 seconds. (Range: 1-
300)
•
retries
— Specifies the maximum number of times to resend an inform request. If
unspecified, the default maximum number of retries is 3. (Range: 1-255)
Default Setting
This command has no default configuration.
Console (config)# snmp-server user
To Next Page
Loading...
