170 LACP Commands
www.dell.com | support.dell.com
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the priority value for port g8 to 247.
lacp timeout
The
lacp timeout
Interface Configuration mode command assigns an administrative LACP
timeout. To reset the default administrative LACP timeout use the
no
form of this command.
Syntax
lacp timeout
{
long | short
}
no lacp timeout
•
long
—Specifies a long timeout value.
•
short
—Specifies a short timeout value.
Default Configuration
The default port timeout value is
long
.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example assigns an administrative LACP timeout for port g8 to a long timeout value.
Console (config)# interface ethernet g8
Console (config-if)# lacp port-priority 247
Console (config)# interface ethernet g8
Console (config-if)# lacp timeout long
To Next Page
Loading...
