242 SNMP Commands
www.dell.com | support.dell.com
2
Map the internal security-name for SNMPv1 and SNMPv2 security models to an internal
group-name.
3
Map the internal group-name for SNMPv1 and SNMPv2 security models to
view-name
(read-view and notify-view always, and for
rw
for write-view also)
• You can use the
group-name
to restrict the access rights of a community string.
By specifying the
group-name
parameter the software:
1
Generates an internal security-name.
2
Map the internal security-name for SNMPv1 and SNMPv2 security models to the
group-
name
.
Examples
The following example sets up the community access string "public" to permit administrative
access to SNMP protocol, at an administrative station with the IP address 192.168.1.20.
snmp-server view
To create or update a view entry, use the
snmp-server view
global configuration command. To
remove the specified Simple Network Management Protocol (SNMP) server view entry, use the
no
form of this command.
Syntax
snmp-server view
view-name
oid-tree
{
included
|
excluded
}
no snmp-server view
view-name
[
oid-tree
]
•
view-name
— Label for the view record that you are updating or creating. The name is
used to reference the record. (Range:1 - 30 chars)
•
oid-tree
— Object identifier of the ASN.1 subtree to be included or excluded from the
view. To identify the subtree, specify a text string consisting of numbers, such as
1.3.6.2.4
,
or a word, such as
system
. Replace a single subidentifier with the asterisk (*) wildcard to
specify a subtree family; for example 1.3.*.4.
•
included
— The view type is included.
•
excluded
— The view type is excluded.
Default Setting
"Default" and "DefaultSuper" views exists.
Command Mode
Global configuration
Console (config)# snmp-server community public su 192.168.1.20
To Next Page
Loading...
