Dell PowerConnect 5324 Command Line Interface Reference Manual

SSH Commands 293
SSH Commands
ip ssh port
The ip ssh port Global Configuration mode command specifies the port to be used by the SSH
server. To use the default port, use the
no form of this command.
Syntax
ip ssh port port-number
no ip ssh port
• port-number —Port number for use by the SSH server (Range: 1 - 65535).
Default Configuration
The default value is 22.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example specifies the port to be used by the SSH server as 8080.
ip ssh server
The ip ssh server Global Configuration mode command enables the device to be configured from a
SSH server. To disable this function, use the
no form of this command.
Syntax
ip ssh server
no ip ssh server
Default Configuration
SSH is enabled.
Command Mode
Global Configuration mode
Console (config)# ip ssh port 8080

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2