Dell PowerConnect 5324 Command Line Interface Reference Manual

166 IP Addressing Commands
www.dell.com | support.dell.com
Syntax
ip host name address
no ip host name
• name— Name of the host (Range: 1 - 158 characters)
•
address— Associated IP address.
Default Configuration
No host is defined.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Examples
The following example defines a static host name-to-address mapping in the host cache.
clear host
The clear host Privileged EXEC mode command deletes entries from the host name-to-address
cache.
Syntax
clear host { name | * }
•
name— Particular host entry to remove. (Range: 1 - 158 characters )
• *—Removes all entries.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
Console (config)# ip host accounting.dell.com 176.10.23.1

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2