Dell PowerConnect 5324 - Port Security Routed Secure-Address; Show Bridge Address-Table

Address Table Commands 85
port security routed secure-address
The port security routed secure-address Interface Configuration mode command adds MAC-layer
secure addresses to a routed port. Use the
no form of this command to delete the MAC addresses.
Syntax
port security routed secure-address mac-address
no port security routed secure-address mac-address
• mac-address —Specify a MAC address in the format of xx:xx:xx:xx:xx:xx.
Default Configuration
No addresses are defined.
Command Mode
Interface configuration (Ethernet, port-channel). Cannot be configured for a range of
interfaces (range context).
User Guidelines
• The command enables adding secure MAC addresses to a routed ports in port security mode.
The command is available when the port is a routed port and in port security mode. The
address is deleted if the port exits the security mode or is not a routed port.
Example
In this example, the MAC-layer address 66:66:66:66:66:66 is added to port g1.
show bridge address-table
The show bridge address-table Privileged EXEC mode command displays all entries in the bridge-
forwarding database.
Syntax
show bridge address-table [ vlan vlan ] [ ethernet interface | port-channel port-channel-
number
]
•
vlan —Specific valid VLAN, such as VLAN 1.
•
interface— A valid Ethernet port .
Console (config)# interface ethernet g1
Console (config-if)# port security routed secure-address
66:66:66:66:66:66