Dell PowerConnect 5324 Command Line Interface Reference Manual

278 Spanning-Tree Commands
www.dell.com | support.dell.com
Example
The following example restarts the protocol migration process (forces the renegotiation with
neighboring switches) on g1.
show spanning-tree
The show spanning-tree Privileged EXEC mode command displays spanning-tree configuration.
Syntax
show spanning-tree [ ethernet interface-number | port-channel port-channel-number ] [ instance
instance-id ]
show spanning-tree [detail] [active | blockedports] [ instance instance-id ]
show spanning-tree mst-configuration
• detail — Display detailed information.
•
active — Display active ports only.
•
blockedports — Display blocked ports only.
•
mst-configuration — Display the MST configuration identifier.
•
interface-number — Ethernet port number. (Range:Valid Ethernet port)
•
port-channel-number — Port channel index. (Range:Valid Ethernet port)
•
instance-id — ID associated with a spanning-tree instance.
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
Examples
The following example displays spanning-tree information.
Console# clear spanning-tree detected-protocols ethernet g1

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2