Dell PowerConnect 5324 Command Line Interface Reference Manual

Ethernet Configuration Commands 139
Example
The following example configures the maximum broadcast rate 10 kilobytes per second.
show ports storm-control
The show ports storm-control Privileged EXEC mode command displays the storm control
configuration.
Syntax
show ports storm-control [ interface ]
•
interface— A valid Ethernet port.
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the storm control configuration.
console(config)# interface ethernet g2
console(config-if)# port storm-control broadcast rate 10
console(config)# port storm-control broadcast rate 333
Console# show ports storm-control
Port Broadcast Storm control [Packets/sec]
----- -------------------------------------
g1 333
g2 Disabled
g3 333
g4 Disabled
g5 Disabled
g6 Disabled
g7 Disabled

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2