Dell PowerConnect 5324 Command Line Interface Reference Manual

164 IP Addressing Commands
www.dell.com | support.dell.com
ip domain-lookup
The ip domain-lookup Global Configuration mode command enables the IP Domain Naming
System (DNS)-based host name-to-address translation. To disable the DNS, use the
no form of
this command.
Syntax
ip domain-lookup
no ip domain-lookup
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Examples
The following example enables the IP Domain Naming System (DNS)-based host name-to-address
translation.
ip domain-name
The ip domain-name Global Configuration mode command defines a default domain name, that
the software uses to complete unqualified host names (names without a dotted-decimal domain
name). To disable use of the Domain Name System (DNS), use the
no form of this command .
Syntax
ip domain-name name
no ip domain-name
• name— Default domain name used to complete unqualified host names. Do not include
the initial period that separates an unqualified name from the domain name.(Range: 1 -
158 characters)
Default Configuration
This command has no default configuration.
Console (config)# ip domain-lookup

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2