Dell PowerConnect 5324 Command Line Interface Reference Manual

192 Management ACL
www.dell.com | support.dell.com
• service service —Indicates service type. Can be one of the following: telnet , ssh , http,
https or snmp .
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
• Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is
defined on the appropriate interface.The system supports up to 256 management access
rules.
Example
The following example shows how all ports are denied in the access-list called "mlist".
management access-class
The management access-class Global Configuration mode command defines which management
access-list is used. To disable restriction, use the
no form of this command.
Syntax
management access-class { console-only | name }
no management access-class
• name —Name of the access list. If unspecified, defaults to an empty access-list.(Range: 1 -
32 characters)
•
console-only —The device can be managed only from the console.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Console (config)# management access-list mlist
Console (config-macl)# deny

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2