EasyManuals Logo

Dell PowerConnect 5324 Command Line Interface Reference Manual

Dell PowerConnect 5324
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #142 background imageLoading...
Page #142 background image
142 GVRP Commands
www.dell.com | support.dell.com
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
An access port would not dynamically join a VLAN because it is always a member in only one
VLAN.
Membership in an untagged VLAN would be propagated in a same way as a tagged VLAN. i.e.
in such a case it’s the administrator’s responsibility to set the PVID to be the untagged VLAN
VID.
Example
The following example enables GVRP on ethernet g8.
garp timer
The
garp timer
Interface Configuration mode command adjusts the GARP application join, leave,
and leaveall GARP timer values. To reset the timer to default values, use the
no
form of this
command.
Syntax
garp timer
{
join
|
leave
|
leaveall
}
timer_value
no garp timer
join
—Indicates the time in milliseconds that PDUs are transmitted.
(Range: 10-2147483640)
leave
—Indicates the amount of time in milliseconds that the device waits before leaving
its GARP state. The Leave Time is activated by a Leave All Time message sent/received,
and cancelled by the Join message. (Range: 10-2147483640)
leaveall
—Used to confirm the port within the VLAN. The time in milliseconds between
messages sent. (Range: 10-2147483640)
timer_value—
Timer values in milliseconds.
Default Configuration
The default timer values are as follows:
Join timer—200 milliseconds
Leave timer—600 milliseconds
Leavall timer—10000 milliseconds
Console (config)# interface ethernet g8
Console (config-if)# gvrp enable

Table of Contents

Other manuals for Dell PowerConnect 5324

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 5324 and is the answer not in the manual?

Dell PowerConnect 5324 Specifications

General IconGeneral
Switching Capacity48 Gbps
VLAN SupportYes
Rack MountableYes
Device TypeSwitch
MAC Address Table Size8K entries
RAM64 MB
Flash Memory8 MB
Power DeviceInternal power supply
Voltage RequiredAC 120/230 V (50/60 Hz)
Jumbo Frame SupportYes
Ports24 x 10/100/1000 + 2 x SFP
ManagementWeb-based, SNMP, CLI
Enclosure TypeRack-mountable
Routing ProtocolStatic IP routing
Remote Management ProtocolSNMP 1, 2, 3
FeaturesFlow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature0 °C to 45 °C
Storage Temperature-20 °C to 70 °C
Humidity5% to 95% (non-condensing)
LayerLayer 2

Related product manuals