Dell PowerConnect 5324 - Ip Igmp Snooping Mrouter-Time-Out

IGMP Snooping Commands 151
Syntax
ip igmp snooping host-time-out time-out
no ip igmp snooping host-time-out
• time-out —Host timeout in seconds. (Range: 1 - 2147483647)
Default Configuration
The default host-time-out is 260 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
• The timeout should be at least greater than 2*query_interval+max_response_time of the
IGMP router.
Example
The following example configures the host timeout to 300 seconds.
ip igmp snooping mrouter-time-out
The ip igmp snooping mrouter-time-out Interface Configuration mode command configures the
mrouter-time-out. The
mrouter-time-out command is used for setting the aging-out time after
multicast router ports are automatically learned. To configure the default mrouter-time-out, use
the
no form of this command.
Syntax
ip igmp snooping mrouter-time-out time-out
no ip igmp snooping mrouter-time-out
• time-out —mrouter timeout in seconds (Range: 1 - 2147483647)
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping host-time-out 300