Dell PowerConnect 5324 Command Line Interface Reference Manual

LACP Commands 171
show lacp ethernet
The show lacp ethernet Privilege EXEC mode command displays LACP information for Ethernet
ports.
Syntax
show lacp ethernet interface [ parameters | statistics | protocol-state ]
•
Interface —Ethernet interface.
Default Configuration
This command has no default configuration.
Command Mode
Privilege EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example shows how to display LACP statistics information.
show lacp port-channel
The show lacp port-channel Privileged EXEC mode command displays LACP information for a
port-channel.
Syntax
show lacp port-channel [ port_channel_number ]
•
port_channel_number —The port-channel number.
Default Configuration
This command has no default configuration.
Console# show lacp ethernet g1 statistics
Port g1 LACP Statistics:
LACP PDUs sent:2
LACP PDUs received:2

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2