Dell PowerConnect 5324 - Show Qos Map

QoS Commands 217
• default-cos —Specifies the default CoS value being assigned to the port. If the port is
trusted and the packet is untagged then the default CoS value becomes the CoS value.
(Range: 0 - 7)
Default Configuration
Port CoS is 0.
Command Mode
Interface Configuration (Ethernet, port-channel) command
User Guidelines
• You can use the default value to assign a CoS value to all untagged packets entering the
port.
Example
The following example configures port g5 default CoS value to 3.
show qos map
The show qos map User EXEC mode command displays all the QoS maps.
Syntax
show qos map [ dscp-queue ]
•
dscp-queue —Displays the DSCP to queue map.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Console (config)# interface ethernet g5
Console (config-if) qos cos 3