Dell PowerConnect 5324 Command Line Interface Reference Manual

160 IP Addressing Commands
www.dell.com | support.dell.com
User Guidelines
• There are no User Guidelines for this command.
Example
The following example defines an ip default gateway.
show ip interface
The show ip interface User EXEC mode command displays the usability status of interfaces
configured for IP.
Syntax
show ip interface [ ethernet interface-number | vlan vlan-id | port-channel number ]
•
ethernet interface-number —port.
•
vlan vlan-id —VLAN number.
•
port-channel number —Port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example the displays the usability status of interfaces configured for IP.
Console(config)# ip default-gateway 192.168.1.1

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2