Dell PowerConnect 5324 Command Line Interface Reference Manual

LLDP Commands 181
Examples
The following example specifies how often the software sends Link Layer Discovery Protocol
(LLDP) updates.
lldp hold-multiplier
To specify the amount of time the receiving device should hold a Link Layer Discovery Protocol
(LLDP) packet before discarding it, use the
lldp hold-multiplier command in global configuration
mode. To revert to the default setting, use the
no form of this command.
Syntax
lldp hold-multiplier number
no
lldp hold-multiplier
• number — Specifies the hold time to be sent in the LLDP update packets as a multiple of
the timer value (Range: 2-10).
Default Configuraiton
The default configuration is 4.
Command Modes
Global configuration
User Guidelines
• The actual time-to-live value used in LLDP frames can be expressed by the following formula:
TTL = min(65535, LLDP-Timer * LLDP-HoldMultiplier). For example, if the value of LLDP
timer is '30', and the value of the LLDP hold multiplier is '4', then the value '120' is encoded in
the TTL field in the LLDP header.
Examples
The following example specifies how often the software sends Link Layer Discovery Protocol
(LLDP) updates.
lldp reinit-delay
To specify the minimum time an LLDP port will wait before reinitializing LLDP transmission, use
the
lldp reinit-delay command in global configuration mode. To revert to the default setting, use
the
no form of this command.
Console (config) # lldp timer
Console (config) # lldp hold-multiplier 6

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2