Dell PowerConnect 5324 Command Line Interface Reference Manual

94 Clock
www.dell.com | support.dell.com
Default Configuration
No external clock source
Command Mode
Global Configuration mode
User Guidelines
• There are no user guidelines for this command.
Examples
The following example configures an external time source for the system clock.
clock timezone
The clock timezone Global Configuration mode command sets the time zone for display purposes.
To set the time to Coordinated Universal Time (UTC), use the
no form of this command.
Syntax
clock timezone hours-offset [ minutes minutes-offset ] [ zone acronym ]
no clock timezone
• hours-offset— Hours difference from UTC. (Range: -12 – + 13)
•
minutes minutes-offset— Minutes difference from UTC. (Range: 0 – 59)
•
zone acronym— The acronym of the time zone. (Range: Up to 4 characters)
Default Configuration
UTC
Command Mode
Global Configuration mode
User Guidelines
• The system internally keeps time in UTC, so this command is used only for display purposes
and when the time is manually set.
Examples
The following example sets the timezone to 6 hours difference from UTC.
Console# clock source sntp
Console# (config)
# clock timezone -6 zone CST

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2