Dell PowerConnect 5324 Command Line Interface Reference Manual

Using the CLI 57
Using the CLI
This chapter describes how to start using the CLI and describes implemented command editing
features to assist in using the CLI.
CLI Command Modes
Introduction
To assist in configuring devices, the CLI [Command Line Interface] is divided into different
command modes. Each command mode has its own set of specific commands. Entering a question
mark "
? " at the system prompt (console prompt) displays a list of commands available for that
particular command mode.
From each mode a specific command is used to navigate from one command mode to another. The
standard order to access the modes is as follows:
User EXEC mode, Privileged EXEC mode, Global
Configuration
mode, and Interface Configuration mode. The following figure illustrates the
command mode access path.

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2