Dell PowerConnect 5324 Command Line Interface Reference Manual

System Management 325
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays a system version (this version number is only for demonstration
purposes).
asset-tag
The asset-tag Global Configuration mode command specifies the device asset tag. To remove the
existing asset tag, use the
no form of the command.
Syntax
asset-tag tag
no asset-tag
•
tag —The device asset tag. (Range: 1- 16 characters)
Router# show version
SW version 3.131 ( date 23-Jul-2002 time 17:34:19 )
HW version 1.0.0
Router# show clock
15:29:03 Jun 17 2002
Router# show history
show version
show clock
show history
3 commands were logged (buffer size is 10)

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2