Dell PowerConnect 5324 Command Line Interface Reference Manual

LLDP Commands 185
show lldp configuration
To display the Link Layer Discovery Protocol (LLDP) configuration, use the show lldp
configuration
command in privileged EXEC mode.
Syntax
show lldp configuration [ethernet interface]
•
Interface — Ethernet port
Command Modes
Privileged EXEC
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the Link Layer Discovery Protocol (LLDP) configuration
show lldp local
To display the Link Layer Discovery Protocol (LLDP) information that is advertised from a specific
port, use the
show lldp local command in privileged EXEC mode.
Syntax
show lldp local ethernet interface
•
Interface — Ethernet port
Switch# show lldp configuration
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
Port State Optional TLVs Addres
g1 RX, TX PD, SN, SD, SC 172.16.1.1
g2 TX PD, SN 172.16.1.1
g3 Disabled

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2