Dell PowerConnect 5324 Command Line Interface Reference Manual

VLAN Commands 347
switchport general acceptable-frame-type tagged-only
The switchport general acceptable-frame-type tagged-only Interface Configuration mode
command discards untagged frames at ingress. To enable untagged frames at ingress, use the
no
form of this command.
Syntax
switchport general acceptable-frame-type tagged-only
no switchport general acceptable-frame-type tagged-only
Default Configuration
All frame types are accepted at ingress.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures g8 to discard untagged frames at ingress.
switchport forbidden vlan
The switchport forbidden vlan Interface Configuration mode command forbids adding specific
VLANs to a port. This may be used to prevent GVRP from automatically making these VLANs
active on the selected ports. To revert to allowing the addition of specific VLANs to the port, use
the
remove parameter for this command.
Syntax
switchport forbidden vlan { add vlan-list | remove vlan-list }
•
add vlan-list —List of VLAN IDs to add to the "forbidden" list. Separate non consecutive
VLAN IDs with a comma and no spaces. A hyphen designates a range of IDs.
•
remove vlan-list —List of VLAN IDs to remove from the "forbidden" list. Separate non
consecutive VLAN IDs with a comma and no spaces. A hyphen designates a range of IDs.
Default Configuration
All VLANs allowed.
Console (config)# interface ethernet g8
Console (config-if)# switchport general acceptable-frame-type
tagged-only

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2