System Management 323
Default Configuration
There is no default configuration for this command.
Command Mode
EXEC mode
User Guidelines
1
Open telnet session from PC 5324 to other device.
2
In the other device syntax, press
Cntrl-shift-t-X
3
Enter the command
show session
. The number of sessions opened from PC 5324 is displayed.
4
Enter the command
resume [number of session]
to return to the relevant telnet session.
Examples
The following table describes the significant fields shown in the display:
show system
The
show system
User EXEC mode command displays system information.
Syntax
show system
Console> show sessions
Connecti
on
Host Address Port Byte
-------- -------------- -------- ----- ----
1 Remote device 172.16.1.1 23 89
2 172.16.1.2 172.16.1.2 23 8
Field Description
Connection Connection number
Host Remote host to which the device is connected through a Telnet session.
Address IP address of the remote host.
Port Telnet TCP port number
Byte Number of unread bytes for the user to see on the connection.
To Next Page
Loading...
