Dell PowerConnect 5324 Command Line Interface Reference Manual

802.1x Commands 381
show dot1x users
The show dot1x users Privileged EXEC mode command displays 802.1X users for the switch.
Syntax
show dot1x users [ username username ]
•
username— Supplicant username (Range: 1- 160 characters)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays 802.1X users.
The following table describes the significant fields shown in the display:
Max req The maximum number of times that the switch sends an Extensible
Authentication Protocol (EAP)-request/identity frame (assuming that no
response is received) to the client before restarting the authentication
process.
Login Time How long the user is logged in.
Last Authentication Time since last authentication.
Mac address The supplicant MAC address.
Authentication Method The authentication method used to establish the session.
Termination Cause The reason for the session termination.
console# show dot1x users
Username Session
Time
Last Auth Auth
Method
MAC Address Interface
-------- ----------- --------- -------- -------------- --------
Bob 1d3h 58m Remote 00:08:3b:79:87:87 g1
John 8h19m 2m None 00:08:3b:89:31:27 g2

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2