EasyManuals Logo

Dell PowerConnect 5324 Command Line Interface Reference Manual

Dell PowerConnect 5324
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
78 Address Table Commands
www.dell.com | support.dell.com
bridge multicast filtering
The
bridge multicast filtering
Global Configuration mode command enables filtering of multicast
addresses. To disable filtering of multicast addresses, use the
no
form of the
bridge multicast
filtering
command.
Syntax
bridge multicast filtering
no bridge multicast filtering
Default Configuration
Disabled. All multicast addresses are flooded to all ports.
Command Mode
Global Configuration mode
User Guidelines
If devices exist on the VLAN, do not change the unregistered multicast addresses state to
drop on the devices ports.
If multicast routers exist on the VLAN and IGMP-snooping is not enabled, the
bridge
multicast forward-all
command should be used to enable forwarding all multicast packets to
the multicast routers.
Example
In this example, bridge multicast filtering is enabled.
bridge multicast address
The
bridge multicast address
Interface Configuration mode command registers MAC-layer
multicast addresses to the bridge table, and adds static ports to the group. To unregister the MAC
address, use the
no
form of the
bridge multicast address
command.
Syntax
bridge multicast address
{
mac-multicast-address
|
ip-multicast-address
}
Console (config)# interface vlan 2
Console (config-vlan)# bridge address 3a:a2:64:b3:a2:45 ethernet
g8 permanent
Console (config)# bridge multicast filtering

Table of Contents

Other manuals for Dell PowerConnect 5324

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 5324 and is the answer not in the manual?

Dell PowerConnect 5324 Specifications

General IconGeneral
Switching Capacity48 Gbps
VLAN SupportYes
Rack MountableYes
Device TypeSwitch
MAC Address Table Size8K entries
RAM64 MB
Flash Memory8 MB
Power DeviceInternal power supply
Voltage RequiredAC 120/230 V (50/60 Hz)
Jumbo Frame SupportYes
Ports24 x 10/100/1000 + 2 x SFP
ManagementWeb-based, SNMP, CLI
Enclosure TypeRack-mountable
Routing ProtocolStatic IP routing
Remote Management ProtocolSNMP 1, 2, 3
FeaturesFlow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature0 °C to 45 °C
Storage Temperature-20 °C to 70 °C
Humidity5% to 95% (non-condensing)
LayerLayer 2

Related product manuals